Relative paths?

BatchPatch Forums Home › Forums › BatchPatch Support Forum › Relative paths?

  • This topic has 3 replies, 2 voices, and was last updated 9 years ago by qwerty017.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 16, 2015 at 6:38 pm #9143
    qwerty017
    Participant

    Is it possible to set relative paths for things like the “Remote Working Directory” and “Local update cache directory”? I am currently having an issue where some of our machines are set up without a C drive and instead start at D so hardcoding it to a C drive does not allow it to work on these machines.

    December 16, 2015 at 6:53 pm #11029
    doug
    Moderator

    There is not currently a way to do this aside from changing the values to “D:whateverwhatever” in the settings.

    -Doug

    December 17, 2015 at 5:26 pm #11030
    qwerty017
    Participant

    Is there a way to change the values for a single computer or will it only change it for all of them? I don’t mind needing to change it everytime for these machines but if I can do a one off change for these few I would like that better.

    December 17, 2015 at 5:31 pm #11028
    doug
    Moderator

    Unfortunately those settings are global, and so they will affect every computer. There is not currently a way to change those two values for just a specific subset of computers. However, we’ll consider this for a future build.

    -Doug

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.